My Cart:

0 item(s) - SGD0.00
You have no items in your shopping cart.


Welcome to TechDeals.Asia!

Contact Us : +65 6816 5656

  • Buyer Protection Guaranteed
  • Free Delivery

More Views

2.4G NF-03 Wireless SPI Mini Module SI24R1 250k~2Mbps Transparent Transmission Receiver For Doorbell Remote Control Switch

Availability: In stock

Regular Price: SGD11.00

Special Price SGD6.00

You Save: SGD5.00 (45%)

Quick Overview

NF-03 is a 2.4G wireless module with small size and on-board antenna. It has a high airspeed (up to 2Mbps), SPI interface, and a pure hardware module. It has high stability, high cost performance and good spectrum test characteristics. , small size, using all industrial grade components.
NF-03 can be widely used in various Internet of Things applications, and is suitable for wireless mouse and keyboard, wireless remote control, somatosensory equipment, active RFID, NFC, low-power self-organizing network wireless sensor network nodes. Ideal solution for IoT applications


1. Stamp hole, ultra-small package, built-in 2.4G antenna, compact size, easy to use
2. Support data reception of six channels
3. Support normal modulation methods such as GFSK/FSK
4. Support 2Mbps/1Mbps/250Kbps data rate
5. Multi-frequency point: 126 frequency points to meet the needs of multi-point communication and frequency hopping communication
6. Internally integrated high PSRR LDO
7. Wide power supply voltage range: 1.9~3.6V
8. Average emission current as low as 110mA
9. Receive sensitivity: [email protected]
10. Maximum transmit power: +7dBm
11. With four-wire SPI interface, the speed can up to 10MHz
12. Internal integrated intelligent ARQ baseband protocol engine
13. Transceiver data hardware interrupt output
14. Support 1bit RSSI output
15. Low application cost: SI24R1 integrates all high-speed signal processing parts related to RF protocol, such as: automatic retransmission of lost data packets and automatic generation of response signals, etc. The SI24R1 SPI interface can be connected with the hardware SPI port of the microcontroller or with a single-chip microcomputer. The I/O port is simulated, and the internal FIFO can interface with various high and low speed microprocessors, which is convenient for using low-cost single-chip microcomputers.
16. Easy to develop: Since the link layer is fully integrated on the module, it is very easy to develop. Automatic retransmission function, automatic detection and retransmission of lost data packets, retransmission time and number of retransmissions. Software control automatically stores the packet auto-answer function without receiving the response signal. After receiving valid data, the module automatically sends a response. Signal, no need to separately program carrier detection - fixed frequency detection built-in hardware CRC error detection and point-to-multipoint communication address control packet transmission error counter and carrier detection function can be used for frequency hopping setting can simultaneously set six receiving channel addresses, which can be selective The open receiving channel stamp hole has a 1.27mm pitch for easy embedded applications.

1VCC-Power supply must be between 2.0 ~ 3.6V
2GND-Ground wire, connected to the power reference ground
3CEInputModule control pin
4CSNInputModule chip select pin for starting an SPI communication
5SCKInputModule SPI bus clock
6MOSIInputModule SPI Data Input Pin
7MISOOutputModule SPI Data Output Pin
8IRQOutputModule interrupt signal output, active low

Module modelNF-03
PackageStamp hole
Communication InterfaceSPI (up to 10Mbps)
Air speed250k~2Mbps 3 levels adjustable (250kbps, 1Mbps, 2Mbps)
Spectrum range2400MHz~2525MHz adjustable, 1MHz stepping
Antenna formOnboard PCB antenna, gain 2dBi
Maximum transmit power7dBm
Receiving sensitivity[email protected]
Average currentEmission current: 25mA (7dBm)
Receive current: 15mA (2Mbps)
Shutdown current: 1.0uA (Shutdown mode)
Power supply range1.9~3.6V, typical value 3.3V
Operating temperature-20 °C ~ 85 °C
Storage environment-20 °C ~ 90 °C, < 90% RH

Package includes:

1 x 2.4G Wireless module


Additional Information

SKU GI/BG/1505054
Weight 0.0040
Last Update 04-September-2019
Estimated Delivery Time 7 to 14 days for Global Inventory

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.